Profile Management; Reset All Settings To Default; Firmware Update - COMPRO IP55 User Manual

Compro IP55 / 60 / 70 Network Camera

Profile Management

The profile management feature allows installers and users to set up more than one camera of similar
configurations at great ease. After the current camera is properly configured, users can export current
camera's configuration to a profile on PC and then load it into other cameras, thereby making least changes
possible like changes on IP address or a few other settings that might need to be modified individually when
configuring a newly added camera. In addition, this feature can also be considered as a backup mechanism
for future service need.
1. After the current camera is properly configured, go to [Maintenance] > [Profile Management], and
click on [Export] to download camera profile to a user-specified location.
2. To load an existing profile into a different camera, log in to the maintenance page of a different
camera, press [Browse...] and locate the profile you wish to load, and then click on [Import] to
proceed.
3. Camera will start to reboot, which will take approximately 60 seconds to complete. Do not interrupt
browser action during the process as doing so may cause problems to your camera system.

Reset All Settings to Default

This will reset IP camera to its factory default settings, producing the same result as pressing the hardware
rest button at the back of camera. If you need to perform hardware reset, refer to the Troubleshooting
chapter.

Firmware Update

You can download the latest firmware from Compro's website (www.comprosecurity.com/en/supports.html).
After downloading the firmware, please log in to the setup page of your IP camera and click [Maintenance]
on the top menu and then look for firmware update section. Press the [Browse] button and locate the
downloaded firmware file and press [Upgrade] button to update camera firmware. Once the update process
begins, it must not be interrupted.
If you log in to the live view page after camera is rebooted and find that some icons are in the wrong place.
Try pressing [Ctrl] + [F5] to force a cache refresh of your browser.
8-2 Maintenance
Caution!
you may only cross-import profile among identical
camera models.
Figure 8-4. Firmware update
Caution!
Before updating firmware, please close all other
browser windows and background applications that are
consuming network bandwidth.