Table of Contents
Advertisement
b. Please check that your computer has a successful connection to
the network.
Computer has connection
c. If you are using the wireless network, please ensure that:
1. The IP camera is connected to the correct wireless access
point.
2. You've correctly set the encryption type and key for the
connection, where applicable.
3. If your network does not have a router then the default IP
address for this camera is at 192.168.0.128.
Note: You can check the status of the connection by logging into
your router -> maintenance -> log or similar wordings in your
router.
Camera Reset
After you've check through the above steps, you should be able to use
the IP Utility to scan for the camera which you've just installed. If
none of the above worked, please reset the camera and follow the
above procedures again.
Once the camera had been reset, please give it 2 minutes to reboot
and start the IP Camera Utility to scan for the camera.
You can reset the camera to the default state
where it will use the onboard LAN connection and
get IP from the available local DHCP server. To
reset the camera, please power on the camera
for 2minutes then press and hold the reset
button on the back of the camera for 10 seconds
in order to reset setting to factory default.
Computer has no connection
33
Advertisement
Table of Contents
