Table of Contents
Advertisement
Static address users: Your IP address and Net Mask are already present in the IP
Configuration table (you entere d them previously). Now you need to enter the additional IP
parameter information you obtained from your LAN administrator:
? ? Default Gateway
? ? DNS Server IP (Primary)
? ? DNS Server IP (Secondary , if applicable)
? ? Domain Name (if applicable)
1. Enter the values for the parameters listed above in the IP Configuration table.
Note: If you do not wish to specify DNS servers, you must enter 0.0.0.0 into the DNS fields.
Do NOT leave them blank. The Max Web Manager will not allow you to save your
configuration settings if these fields are left blank.
2. Click Save when you are finished.
3. Click the Restart System link to access the Restart System page then select Click to
restart system to reboot your Net2Phone MAX 4 system.
? ? The default values in the Network Configuration table do not require change
unless a firewall is in use.
? ? The default values in the Voice Configuration table should normally be left
unchanged.
For additional configuration information, refer to the Net2Phone MAX 4 User Guide.
Configure Account
Click the Account Config link to access the Account Information page, illustrated below.
Figure 6
Page 8
Advertisement
Table of Contents
