Optical Parts Disassemblies - Sanyo PLC-XT10 Service Manual

■ Optical Parts Disassemblies

Before taking this procedure, remove Cabinet Top and Main Board following to the "Mechanical Disassemblies".
Disassembly requires a 2.0mm hex wrench.
1
Projection Lens removal
1
Shift the projection lens to the end of top position by pressing
the Lens Shift (+) button.
2
Remove the Cabinet Front-Top and Lens Holder following to
the chapter "Mechanical Disassemblies".
3
Press and hold the Fixing Lever
Lens counter-clockwise(1/6 turn) and then take it off.
Lever-A
2
Polarized Glass-In removal
1
Remove each hex screw and pull the Polarized Glass-In ass'y upward.
2
Remove a stopper and take the glass off upward.
A
and turn the Projection
Fig.1-
1
Fig.2-
1
-13-
Note in the Mounting Projection
Lens
Insert the Projection lens into the guide at a
position where the both markers on the pro-
jection lens and the mounting base come
together, and turn it clockwise until the Fixing
Lever is set to the fixing position.
Point Markers
Part No. is printed on
upper side.
* Glass should be placed as the
printed marker comes to the
upper left corner.
Lever-A
Fig.1-
2
polarized glass
Phase Sheet
Fig.2-
2