Mechanical Disassemblies - Sanyo PLC-XT10 Service Manual

■ Mechanical Disassemblies

Mechanical disassemble should be made following procedures in numerical order.
Following steps show the basic procedures, therefore unnecessary step may be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original otherwise it may cause loss of
performance and product safety.
1
Cabinet Top removal
1
Turn the Lens Front Cover counter-clockwise and take it
off by pulling forward as shown in Fig.1-1.
2 A
Remove 2 screws (M4x10) to take the Cabinet Front-
Top off.
3 B
Remove 5 screws (M4x10)
Top upward off.
B
B
B
and then
take the Cabinet
Cabinet Front-Top
B
B
Fig.1-
2
A
-8-
Screws Expression
(Type ) mm
Diameter x Length
T type M Type
A
Lens
Front
Cover
Fig.1-
1