Alarm Display On The Graphics Pages; Sensor Failure - Man D2868 LE433 Operating Instructions Manual

Table of Contents

k) Range:

The range of the ship is displayed on the right.

This is a value calculated from the current fuel consumption, GPS speed and current fuel tank content.

The range can be displayed in nautical or standard miles, which can be selected in the menu.

Furthermore, the fuel consumption and e.g. the position of the bathing ladders are often displayed on

page 2.

The

(2) and

pages. If the alarm table is activated, the last displayed page is opened.

All sensors and switch inputs connected to the serial substation must be provided by the shipyard and

tested for proper function as well as conformity with the serial substation. Furthermore, the serial substation

must have been configured. The same applies to the GPS system that is connected directly to the CLC

ship.

Alarms

Should an alarm condition occur, an alarm table is automatically displayed. This lists all advance warnings,

alarms and sensor fault alarms. An internal buzzer and the horn relay are activated at the same time.

The collective alarm relay issues a repeat pulse if another alarm was already active. In this way, it is pos

sible to activate a visual call system for each new alarm or to send a telephone message if the ship is not

occupied. Acoustic acknowledgement with the

sent on the CAN bus to the engine monitoring and diagnostic unit and to all the monitoring devices connec

ted to the same CAN bus. All the equipment thus has the same alarm status.