Setup - Formax FD 380 Operator's Manual

SETUP

1. Install upper and lower fold plates in position. Be sure
the plates are set fi rmly on the locating pins (Fig 1a &
1b). Slide the fold plate in until it meets the fi rst locating
pin then push down to lock it in position (Fig. 2).
2. Plug the fold plate cables into the receptacles on the
side frame (Fig. 3a & 3b).
3. Make sure the power switch is in the "OFF" position.
4. Plug the power cord into the power inlet and the wall
outlet.
Upper Fold Plate Pins
Fig. 1a
Lower Fold Plate Pins
Fig. 1b
Locating Pins
Locating Pins Locating Pins Locating Pins Locating Pins
Fig. 2
Upper Fold Plate Receptacle Location
Fig. 3a
Lower Fold Plate Receptacle Location
Fig. 3b
2
Plug in Receptacle
Plug in Receptacle