Kyocera FS-C2026MFP Operation Manual page 434

Symptom
Images are skewed.
Paper often jams.
Printouts are
wrinkled.
Cannot print.
Documents are
printed improperly.
While the operation
panel was being used,
the keys locked up
and do not respond
when pressed.
Checkpoints
Are the originals placed
correctly?
Is the paper loaded
correctly?
Is the paper loaded
correctly?
Is the paper of the supported
type? Is it in good condition?
Is the paper curled, folded or
wrinkled?
Are there any loose scraps or
jammed paper in the
machine?
Is the paper damp?
Is the paper set in a proper
orientation?
Is the machine plugged in?
Is the machine powered on?
Is the printer cable or
network cable connected?
Was the machine powered
on before the printer cable
was connected?
Is the print job paused?
Are the application software
settings at the PC set
properly?
Is the operation panel
locked?
Corrective Actions
When placing originals on the
platen, align them with the original
size indicator plates.
When placing originals in the
document processor, align the
original width guides securely
before placing the originals.
Check the position of the paper
width guides.
Load the paper correctly.
Remove the paper, turn it over, and
reload it.
Replace the paper with new paper.
Remove any jammed paper.
Replace the paper with new paper.
Change the orientation in which the
paper is positioned.
Plug the power cord into an AC
outlet.
Turn on the main power switch.
Connect the correct printer cable or
network cable securely.
Power on the machine after
connecting the printer cable.
Press [Resume] (the Left Select
key) to resume printing.
Check that the printer driver and
application software settings are
set properly.
Check the panel lock setting in
COMMAND CENTER and change
the setting if necessary.
10-4
Troubleshooting
Reference
Page
2-44
2-45
2-45
2-26
2-26
2-26
10-16
2-26
—
—
2-7
2-5
2-5
2-7
7-18
—
KYOCERA
COMMAND
CENTER
Operation
Guide