Matrix U5x-05 Service Manual page 69

CHAPTER 10: BIKE SPECIfICATIoNS AND ASSEMBly gUIDE
10.5 TV BRACKET INSTAllATIoN INSTRUCTIoNS - CoNTINUED
18) There should now be 4 wires sticking out the top of the console - TV power wire, net wire, coax cable, and controller wire (Figure T).
19) Re-attach the console back to the front using the bottom 6 screws removed in Step 2. note: Be sure to route the wiring so that it is not
pinched by the bracket or plastic when installing the top 2 screws (Figure U). The small cover with the Matrix logo that makes up the top of the
rear console cover is no longer used with a TV bracket.
20) Mount the console back onto the unit making sure to make all the necessary wire connections including the coax cable.
fIgURE T fIgURE U
21) Mount the plastic front plate to the TV (Figure V).
22) Plug the coax cable into the back of the TV (Figure W).
MyE TV PCTV
fIgURE V fIgURE W
23) Plug the power wire into the back of the TV (Figure X).
24) Plug the controller wire into the back of the TV (Figure Y). note: The controller wire should be plugged into the PCTV port on the PCTV.
MyE TV PCTV MyE TV PCTV
fIgURE x fIgURE y
66