Connection Box - Permobil X850 Service Manual

Permobil X850

Connection box

Removal
1. Place the wheelchair on a level surface. If the chassis
has an electric seat lift, raise the seat to the highest
position. If the seat lift does not work normally be-
cause the batteries are discharged or the motor is de-
fective, see page 22. If the chassis has a fixed seat,
tip the seat forwards. See page 22.
2. Switch off the power supply using the ON/OFF key on
the control panel and switch the automatic main fuse
to Off. It is accessible via a recess on the chassis.
See page 36.
3. Remove the chassis covers. See page 7.
4. Remove the electronics. See the previous page.
5. Remove all electrical connections from the connec-
tion box and release the cabling from the quick-re-
lease mountings.
6. If the chassis has electric wheelbase adjustment, di-
vide the wheelbase adjustment's electrical connec-
tion at the contact on the cabling. See page 25.
7. Remove the connection box. It is held in place with
two screws on the rear of the chassis. See the illustra-
tion. Lift the connection box straight up out of the
chassis.
Assembly
Install in the reverse order. Make sure that all contacts
are connected correctly.
Figure 68. 1: Connection box.
2: Electronics.
Figure 69. The connection box is held in place with two
Figure 70. The connection box's electrical connections.
screws
Repairs
45