Permobil X850 Service Manual page 32

Permobil X850
Removal
1. Place the wheelchair on a level surface. Raise the
seat to the highest position. If the seat lift does not
work normally because the batteries are discharged
or the motor is defective, see page 22.
2. Switch off the power supply using the ON/OFF key on
the control panel and switch the automatic main fuse
to Off. It is accessible via a recess on the chassis.
See page 36.
3. Remove the chassis covers. See page 7.
4. Divide the control panel's cabling at the contact on
the cabling on the rear of the seat. Loosen any cable
ties that hold the cabling in place.
5. Remove the seat lift's cabling connection from the
connection box. See the illustration. If the chassis has
electric seat rotation, remove the seat rotation's ca-
bling connection from the connection box. See the
illustration.
6. Remove the cabling from the quick release mount-
ings on the seat lift.
7. Remove the seat. It is held in place with two screws.
See the illustration.
NOTE!
The seat is heavy. Two people should therefore lift it.
Be careful with the cabling.
8. Remove the batteries. See page 10.
9. Remove the screw and locking nut (1) that hold the
seat lift in place at the rear. See the illustration below.
10. Remove the screws (2) on both sides of the seat lift at
the bottom of the mounting.
11. Lift the seat lift straight up out of the chassis.
Assembly
Install in the reverse order.
32
Figure 38. Electrical connections of the seat lift and seat
Figure 39. The seat is held in place with two screws.
Figure 40. Removing/installing the electric seat lift.
rotation.
Repairs