Brake Release Cables - Permobil X850 Service Manual

Permobil X850

Brake release cables

Removal
1. Place the wheelchair on a level surface. If the chassis
has an electric seat lift, raise the seat to the highest
position. If the seat lift does not work normally be-
cause the batteries are discharged or the motor is de-
fective, see page 22. If the chassis has a fixed seat,
tip the seat forwards. See page 22.
2. Switch off the power supply with the On/Off key on
the control panel.
3. Remove the chassis covers. See page 7.
4. Remove the brake release mechanism. It is held in
place with two screws. See the illustration.
5. Loosen the locking nut (1).
6. Screw the adjusting screw (2) fully in.
7. Loosen the cable at the magnetic brake by pulling the
cable sheath forwards and pass the cable out through
the groove of the cable holder. Detach the brake re-
lease cable from the magnetic brake.
8. Screw the adjusting screw (2) fully out and loosen the
cable at the release lever.
24
Figure 21. The brake release mechanism is held in place
with two screws.
Figure 22. Adjustment of brake release cables. Locking
nut (1). Adjusting screw (2)
Figure 23. The brake release cable's attachment to the
magnetic brake
Repairs