Declaration Of Conformity - ESAB Aristo F 300 Instruction Manual

The Low Voltage Directive 2006/95/EC of 12 December 2006, entering into force 16 January 2007
The EMC Directive 2004/108/EC of 15 December 2004, entering into force 20 January 2005
Type of equipment
Wire feeder for MIG/MAG welding
Brand name or trade mark
ESAB
Type designation etc.
Aristo F 300 Valid from serial number 033 xxx xxxx (2010 w.33)


Aristo F 300 may be used with different MMC panels in combinations with or without water
Manufacturer or his authorised representative established within the EEA
Name, address, telephone No, telefax No:
ESAB AB, Welding Equipment
Esabvägen, SE- -695 81 LAXÅ, Sweden
Phone: +46 584 81 000, Fax: +46 584 411 924
The following harmonised standard in force within the EEA has been used in the design:
EN 60974- -5, Arc welding equipment – Part 5: Wire feeders
EN 60974- -10, Arc welding equipment – Part 10: Electromagnetic compatibility (EMC) requirements
Additional information: Restrictive use, Class A equipment, intended for use in locations other than residential
By signing this document, the undersigned declares as manufacturer, or the manufacturer's authorised
representative established within the EEA, that the equipment in question complies with the safety
requirements stated above.
Place and Date
Laxå 2010- -09- -10

DECLARATION OF CONFORMITY

According to
Signature
Kent Eimbrodt
Clarification
- 2 -
Position
Global Director
Equipment and Automation