Table of Contents
Advertisement
VMT8000 series
3.1 Operating location
The device is designed for use on support arm systems, wall and table mounting or on vehicles
(commissioning trolleys, forklifts or similar). You have to take care that the environmental conditions
specified in the technical data are met. Use in non-specified environments, i.e., on board ships, in
explosive atmospheres or at extreme elevations, is prohibited.
The device must not be used to control vehicles. It must be ensured that the device is installed properly.
ATTENTION
Hazard due to condensation
Damage to electronic components caused by
condensation resulting from temperature
fluctuations.
The device should only be switched on after it
has acclimated to the ambient temperature!
To avoid overheating in operation: The device
must not be exposed to direct radiation by
sunlight or any other heat source.
3.2 Damage due to improper use
Should the control system have evident signs of damages caused, e.g., by improper operation or
storage conditions or due to improper use or handling, the device must be shut down immediately.
Ensure that it is secured against being started up accidentally.
3.3 Warranty / repairs
During the device warranty period, any repairs must only be performed by the manufacturer or by
service personnel that has been authorised by the manufacturer.
3.4 Intended use
The device is used for visualisation and control as well as the acquisition of operating and machine data
in the production environment. Another typical application is in logistics. Here, the device can be used
for mobile data acquisition.
The device is only to be assembled, installed and operated within the permissible specifications.
Use in non-specified environments is prohibited.
3.5 Improper use
Operation other than or beyond that described for the device shall be deemed improper use.
The device is not allowed to be used to control vehicles or for applications for which further approvals
beyond the manufacturer's declaration are necessary, e.g. applications with explosion hazard, medical
technology, shipping industry.
The device must not be put into operation in the case of transport damage or nonconformity with the
specifications and, if necessary, must be taken out of operation in the case of changing conditions.
In the case of improper use, ads-tec shall not accept responsibility or liability for injury or damage that is
directly or indirectly attributable to the handling of the device.
Should the device have evident signs of damages caused, e.g., by improper operation or storage
conditions or due to improper use or handling, it must be shut down immediately. Ensure that it is
secured against being started up accidentally.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
9
Advertisement
Table of Contents
