Table of Contents
Advertisement
VMT7000 series
3.1 Operating location
The device is designed for use on support arm systems, wall and table mounting or on vehicles
(commissioning trolleys, forklifts or similar). You have to take care that the environmental conditions
specified in the technical data are met. Use in non-specified environments, i.e., on board ships, in
explosive atmospheres or at extreme elevations, is prohibited.
The device must not be used to control vehicles. It must be ensured that the device is installed properly.
ATTENTION
Hazard due to condensation
Damage to electronic components caused by
condensation resulting from temperature
fluctuations.
The device should only be switched on after it
has acclimated to the ambient temperature!
To avoid overheating in operation: The device
must not be exposed to direct radiation by
sunlight or any other heat source.
3.2 Damage due to improper use
Should the control system have evident signs of damages caused, e.g., by improper operation or
storage conditions or due to improper use or handling, the device must be shut down immediately.
Ensure that it is secured against being started up accidentally.
3.3 Warranty / repairs
During the device warranty period, any repairs must only be performed by the manufacturer or by
service personnel that has been authorised by the manufacturer.
3.4 Intended use
The device is used for visualisation and control as well as the acquisition of operating and machine data
in the production environment. Another typical application is in logistics. Here, the device can be used
for mobile data acquisition.
The device is only to be assembled, installed and operated within the permissible specifications.
Use in non-specified environments is prohibited.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
9
Advertisement
Table of Contents
