Operating And Safety Instructions - ADS-tec VMT8000 series Instruction Manual

VMT8000 series

3 Operating and safety instructions

The device operates under electrical voltage and contains highly sensitive components. Intervention by
the user is required only for connecting the power supply lines. Should any further modifications be
required, it is necessary to consult either with the manufacturer directly or with service personnel
authorised by the manufacturer. The device must be de-energised during work. Appropriate measures
must be taken to prevent electrostatic discharges on components. If the device is opened up by an
unauthorised person, the user may be subject to hazards and the warranty is invalidated.
General information
 All users must read this manual and have access to it at all times.
 Assembly, commissioning and operation may only be performed by qualified and
trained personnel.
 The safety notices and the manual itself must be observed by all persons who
work with this device.
 At the installation site the valid guidelines and regulations for accident prevention
must be observed.
 The manual contains the most important instructions on how to use this device in
a safe way.
 Appropriate storage, proper transport, installation and commissioning, as well as
careful operation are prerequisites for ensuring safe and proper operation of the
device.
 The device can be cleaned by using a soft cloth and a commercially available
glass cleaning agent (e.g. Sidolin) with low alcohol content.
ATTENTION
Hazard due to damage to device
Damage caused by connected peripherals or
data loss
 All cable lines (power supply, interface cables)
should only be connected while the device is
switched off and de-energised.
© ads-tec GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen
8