Basic Position Of The Machine Drive Unit; On Machines With Quick-Ecodrive And Control Unit P40 Ed - Pfaff 1181 Instruction Manual

Installation and commissioning
8

Basic position of the machine drive unit

.05
8

On machines with Quick-EcoDrive and control unit P40 ED

.05.01
●
●
●
●
●
●
●
●
●
●
●
●
24
Switch on the machine.
Press the TE/speed key twice to select the input mode.
Select parameter "798" by pressing the corresponding +/- key, and select service level
C, see Chapter Selecting the user level in the instruction manual for the control panel.
By pressing the corresponding +/- key select the parameter "799" (Selecting the machine
class).
Check whether value "1" is set, and correct it if necessary.
If the parameter has to be altered, operate the TE/Speed key and then switch
off the machine and switch it on again. Then select service level C again as de-
scribed above.
By pressing the corresponding +/- key, select parameter "800" (selecting the sewing
direction).
By pressing the corresponding +/- key, select the value for the parameter at "0".
By pressing the corresponding +/- key, select parameter "700".
Sew a stitch by operating the pedal.
Turn the balance wheel in the sewing direction until the descending needle is level with
the top edge of the needle plate.
Then check the parameter values listed in the parameter list (see Chapter
10.04 Parameter Settings) and adjust them if necessary.
Conclude the adjustment of the sewing motor by pressing the TE/Speed key.