Mounting The Toothed Belt / Basic Position Of The Machine Drive Unit - Pfaff 3734-12 Instruction Manual

Mounting and commissioning the machine
8

Mounting the toothed belt / Basic position of the machine drive unit

.02.04
2 x
No
8 - 5
Switch on the machine.
Press TE/Speed key twice to select the input mode.
TE
No
101
Select the parameter group "600" by pressing the corresponding +/- key.
TE
No
600
Confirm the selection by pressing the corresponding +/- key.
Enter the code number, see Chapter 9.08 Entering/changing the code number.
TE
No
603
Select the parameter group "603" by pressing the corresponding +/- key.
Turn the motor shaft by hand until value "11" appears in the display.
Turn the balance wheel in sewing direction until the needle point descending from above,
is level with the top edge of the needle plate.
Taking care not to turn the motor shaft 4 (Fig. 8 - 07) or the machine, fit synchronous
belt 5.
2.5 2.5
VAL
II
VAL
11