Mounting The Toothed Belt / Basic Position Of The Machine Drive Unit On The 1571 And 1591 - Pfaff 1571 Instruction Manual

8 Mounting the toothed belt /
.02.04
Basic position of the machine drive unit on the 1571 and 1591
Switch on the machine.
2 x
Press TE/Speed key twice to select the input mode.
No
Select the parameter group "600" by pressing the corresponding +/- key.
Confirm the selection by pressing the corresponding +/- key.
Enter the code number, see Chapter 9.10 Entering/changing the code number.
Select the parameter group "603" by pressing the corresponding +/- key.
Turn the motor shaft by hand until value „8" appears in the display.
Turn the balance wheel in sewing direction until the needle point descending from above,
is level with the top edge of the needle plate.
Taking care not to turn the motor shaft 4 (Fig. 8 - 07) or the machine, fit synchronous
belt 5.
Installation and commissioning
2.5 2.5
TE
No VAL
101 II
TE
No
600
TE
No VAL
603 8
8 - 5