Basic Position Of The Machine Drive Unit - Pfaff 521 Instruction Manual

Mounting and commissioning the machine
8

Basic position of the machine drive unit

.02.07
2 x
No
8 - 7
Switch on the machine.
Press TE/Speed key twice to select the input mode.
TE
No
101
Select the parameter group "600" by pressing the corresponding +/- key.
TE
No
600
Confirm the selection by pressing the corresponding +/- key.
Enter the code number, see Chapter 9.09 Entering/changing the code number.
TE
No
603
Select the parameter group "603" by pressing the corresponding +/- key.
Turn the balance wheel in the direction of sewing, until the needle point is on a level with
the top edge of the needle plate.
Turn the motor shaft by hand until value "8" appears in the display.
2.5 2.5
VAL
II
VAL
8