Installer Guide; Getting Started; Typical Appliance System - Heat & Glo Crescent II Owner's Manual

4 4

Getting Started

A. Typical Appliance System
NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not
drawn to scale. Actual product varies from pictures in manual.
Note: The fi gures on this page do not represent the
Crescent II specifi cally. They are intended to show
the typical components of the gas fi replace system.
NON-COMBUSTIBLE ROOF FLASHING
MAINTAINS MINIMUM CLEARANCE
AROUND PIPE (SECTION 10.F)
VENT PIPE (SECTIONS 7 and 8)
CEILING FIRESTOP
ON FLOOR OF ATTIC
(SECTION 8.C)
FRAMING/HEADER
(SECTION 5)
GAS LINE
SECTION 11.C
Figure 4.1 Typical System
16

Installer Guide

VERTICAL TERMINATION CAP
(SECTION 10.G)
STORM COLLAR
(SECTION 10.F )
VENT PIPE PENETRATES ROOF
PREFERABLY WITHOUT AFFECTING
ROOF RAFTERS (SECTION 10.E )
ATTIC INSULATION SHIELD (NOT
SHOWN) MUST BE USED HERE TO
KEEP INSULATION AWAY FROM
VENT PIPE IF ATTIC IS INSULATED
(SECTION 8.D )
Heat & Glo • Crescent II • 2083-902 Rev. U • 4/15
HORIZONTAL
TERMINATION CAP
(SECTION 10.I)
FRAMING HEADED OFF
IN CEILING JOISTS
(SECTION 8.C)
OPTIONAL
WALL SWITCH
MANTEL AND
MANTEL LEG
(SECTION 5.D & 13.A)
SURROUND