Electrical Information; Wiring Requirements; Circuit Board; Optional Accessories Requirements - Heat & Glo Crescent II Owner's Manual

Hide thumbs Also See for Crescent II:
Table of Contents

Advertisement

12
12

Electrical Information

A. Wiring Requirements
NOTICE: This appliance must be electrically wired
and grounded in accordance with local codes or, in the
absence of local codes, with National Electric Code
ANSI/NFPA 70-latest edition or the Canadian Electric
Code CSA C22.1.
• Wire the appliance junction box to 110-120 VAC. This is
required for proper operation of the appliance.
• A 110-120 VAC circuit for this product must be protected
with ground-fault circuit-interrupter protection, in
compliance with the applicable electrical codes, when
it is installed in locations such as in bathrooms or near
sinks.
• Low voltage and 110 VAC voltage cannot be shared
within the same wall box.
WARNING! Risk of Shock or Explosion! DO NOT wire
110V to the valve or to the appliance wall switch. Incorrect
wiring will damage controls.
38
Heat & Glo • Crescent II • 2083-902 Rev. U • 4/15
B. Intellifi re Ignition System Wiring and 3
Function Circuit Board
This appliance requires a 110-120 VAC supply to the ap-
pliance junction box for operation. A wiring diagram is
shown in Figure 12.1.
This appliance is equipped with an Intellifi re control valve
which operates on a 3 volt system.
This appliance is equipped with a 3 function circuit board
which operates on 110-120 VAC and 12 VDC.
This appliance is supplied with a 3 volt AC transformer
and a 12 volt DC transformer, which requires the installa-
tion of the supplied junction box. It is highly recommend-
ed that the junction box be installed at this time to avoid
reconstruction.
Optional Remote Control Requirements
To attach remote receiver in series with 3 function wall
switch see wiring diagram. See Figure 12.2.
C. Optional Accessories Requirements
• This appliance may be used with a wall switch, wall
mounted thermostat and/or a remote control.
Wiring for optional Hearth & Home Technologies approved
accessories should be done now to avoid reconstruction.
Follow instructions that come with those accessories.

Advertisement

Table of Contents
loading

Table of Contents