Drive Cage And Drive Cable - HP 260 G1 Maintenance And Service Manual

Drive cage and drive cable

The drive cage is located next to the heat sink and is secured with four Torx screws. The drive cable routes
through a slot in the drive cage. When removing the drive cage, lift the cage up to access the drive cable
connector underneath, and then disconnect the cable. Then you can slide the cable out of the drive cage.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the hard drive
4. Remove the four Torx screws (1) that secure the drive cage to the computer.
32 Chapter 4 Removal and replacement procedures
(Preparation for disassembly on page
(Access panel on page
(Hard drive on page 19).
18).
17).