Table of Contents
Advertisement
Drive power cable
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Disconnect the cable from the optical drive (1) and the hard drive (2)
4.
Remove the cable from the clips on the base pan and on the side of the hard drive cage (3).
5.
Disconnect the cable from the system board connector labeled SATAPWR0 (4), and then remove the
cable from the computer.
To reinstall the drive power cable, reverse the removal procedure.
(Preparation for disassembly on page
(Access panel on page
21).
20).
Drive power cable
41
Advertisement
Table of Contents
