Removing The If Panel, Rc Board Assy., Rcr Cable; Fif, If Board Assy - Epson EMP-TW1000 Service Manual

4.2.10 Removing the IF Panel, RC Board Assy., RCR Cable; FIF, IF Board
Assy.
1. Remove the one screw (C.C.SCREW, 3x6, F/Z-3C) that secures the RC Board Assy.
2. Remove the two screws (C.P.B-TITE-A.SCREW, 3x8, F/NI) that secure the D-terminal
connector, and remove the four screws (Screw, HSH 4-40) that secure the D-SUB
connector.
3. Remove the screw (C.C.SCREW, 3x6, F/Z-3C) that secures the HDMI connector, remove
the three screws (C.B.P-TITE SCREW, 3x10, F/ZB-3C) that secure the S-component, and
remove the IF Panel from the MA-IF Board Assy.
4. Remove the screw (C.C.SCREW, 3x6, F/ZN-3C) that secures the RC Board Assy., and
remove the RC Board Assy. from the IF Panel.
5. Remove the RCR Cable; FIF from the RC Board Assy.
C.C.SCREW, 3x6, F/Z-3C
SEIKO EPSON
EMP-TW1000
Printed Circuit Board Assembly; RC_R1
C.P.B-TITE-A.SCREW, 3x8, F/NI
Figure 4-22.
4-25
Cable, RCR; FIF
IF panel
C.C.SCREW, 3x6, F/Z-3C
C.B.P-TITE SCREW, 3x10, F/ZB-3C
Revision:A