Adjusting The Cutting Height - Craftsman 320.37596 Operator's Manual

ADJUSTING THE MITER
GAUGE (Fig. 22)
_, WARNING: Failure to unplug
your router before performing
adjustments to the router or table
could result in accidental starting
causing serious injury.
1. Loosen the miter gauge knob.
2. Rotate the miter gauge to the
desired angle.
3. Tighten the miter gauge knob.
ADJUSTING THE CUTTING HEIGHT
2.
3.
WARNING: Failure to unplug your router before performing adjustments to
the router or table could result in accidental starting causing serious injury.
Select the appropriate hole to adjust the router to the table according to Table 2
and Fig. 6.
NOTICE: A hex wrench is required for this operation (not included).
1. Turn off the table switch by pressing the ON/OFF
switch panel.
Loosen the clamping lever on
the router.
4.
Insert the hex wrench into the
adjusting hole on the tabletop
(Fig. 23), and turn the router
adjustment dial with the hex
wrench to move the router
collet up or down.
When the desired cutting
height is set, tighten the
clamping lever on the router.
37596 Manual_Revised_12
121i
Page 23