Craftsman 320.37596 Operator's Manual page 17

TO ATTACH THE MITER
GAUGE (Fig. 9)
The miter gauge has been
shipped completely assembled.
Attach the miter gauge to the
table by placing the miter gauge
bar in the slot on the table.
TO iNSTALL TABLETOP iNSERT
RINGS (Fig. 10}
This router table includes five
tabletop insert rings with the
following hole sizes:
• 1-1/4 in. diameter, for use
with bits with diameters up to
1-1/8 in.
1-7/8 in. diameter, for use
with bits with diameters up to
1-3/4 in.
2-1/8 in. diameter, for use
with bits with diameters up
to 2 in.
Fig. 9
Fig. 10
2-1/2 in. diameter, for use
with bits with diameters up to 2-3/8 in.
Blank plate
_ 1-1/4 in. Dia
1-7/8 in. Dia
(_---2-1/8 in. Dia
O__j....-_2-1/2 in. Dia
The blank plate may be drilled with a hole to match a bit whose diameter is not
included in the list above. Make sure that the size of the hole is 1/8 in. larger
than that of the bit. The blank plate may be used to prevent dust from entering
the router below.
1. Position the tabletop insert over the inset opening in the router table.
2. Press the insert into the inset opening in the router table.
3. Press down evenly over the tabs until the insert locks into place.
4. To remove, pull up gently until the tabs disengage. When not in use, store
the tabletop inserts in a convenient place.
37596 Manual_Revised_12 1211 Page 17