Craftsman 320.37596 Operator's Manual page 18

MOUNTING THE TABLE TO A
WORK SURFACE {Fig. 11)
1. Set the router table on a
workbench or other stable
and sturdy surface, with
the FRONT (switch side)
of the router table facing
towards you.
2. While holding the router
table in the desired position,
mark the location of the four
mounting holes (11,/32 in.
dia.) in each the four corners.
3. Remove the router table.
4. Drill an 11/32 in. pilot hole (for bolts) at the marked locations.
5. Place the router table on the workbench and align the mounting holes in the
router table legs with the holes drilled in the workbench.
6. Secure the router table in place using nuts (not provided) and washers (not
provided) to thread the bolts through the pilot holes.
7. Tighten all hardware (not supplied) securely with the corresponding tool to
your hardware.
ATTACH THE FEATHER
BOARDS (Fig. 12 and 13)
WARNING: Always unplug
the router before attaching or
removing the feather boards.
NOTICE: The front and back
side of each feather board is
marked to indicate proper feed
direction. The direction of the
arrow marked on the feather
board must be consistent with the
in-feed direction.
Attach the feather board to
the fence
1. Place the feather board on
the fence as shown in Fig. 12.
Fig. 13
o o
Page 18 37596 ManuaLRevised 12-1211