Advertisement
20
Dell Latitude CPt V/CPt S Series and CPx H/CPx J Series Service Manual
'LVSOD\$VVHPEO\
display assembly
hinge cover
LCD flex cable
snap tab
bottom case assembly
)LJXUH'LVSOD\$VVHPEO\
5HPRYLQJWKH'LVSOD\$VVHPEO\
127,&( 7RDYRLGGDPDJLQJWKHV\VWHPERDUG\RXPXVWUHPRYHWKH
PDLQEDWWHU\EHIRUH\RXVHUYL.HWKH.RPSXWHU
127,&( 'RQRWUHPRYHWKHSDOPUHVWEHIRUH\RXUHPRYHWKHGLVSOD\
1. Remove the main battery and secondary battery (if present).
2. Remove the keyboard.
3. Close the display and remove the three 4-mm screws, labeled with a
" circle D," from the back of the computer (see Figure 13).
4. Open the display and disconnect the LCD flex cable from the connector on
the system board by pulling the connector straight up.
5. Lift the display assembly from the bottom case assembly. Pry the hinge
cover loose at the seam from the snap tabs on the bottom assembly (see
Figure 13).
NOTE: Always remove and replace the LCD panel as a complete assembly.
4-mm screws (3)
snap tab
M2.5x4
Advertisement
