Remote Control Installation - Pacific energy Broadway Installation And Operating Instructions Manual

Remote Control Installation

Caution: DO NOT connect the batteries to the remote control receiver until the all of the wires are
connected to the gas valve as a short circuit could result in damage to the electrical components of
the remote control.
When installing the remote to the fi replace please refer to fi gures 10 and 11.
1) The wiring harness should be already connected to the remote receiver box, but if its not push the wire
connector onto the reciever circuit board, it will only fi t one way.
2) Connect the smaller of the "L" shaped terminals to the smaller motor terminal on the gas valve.
(connectors marked "A" to the terminals marked "B" in Figures 10 and 11) Repeat with the larger terminal.
3) Connect wires "C" to the gas valve terminals marked "D" in fi gures 10 and 11
4) Remove the remote control reciever lid by sliding it away from the "wiring end" and lifting up.
5) Install four 1.5V "AA" batteries. and replace lid.
6) Place the reciever below the gas valve.
7) Remove the battery cover from the bottom of the remote hand set, install one 9V battery and replace the
battery cover.
Fig# 10
Wire conector
on circuit board
8
161204-24
C
A
Fig # 11
D
B
# 5055.6591