Disassembly Method - JVC RS-WP1WT Service Manual

Disassembly method

Removing the front panel assembly /
rear panel assembly (See Fig.1)
1. Remove the nine screws A attaching the rear panel
assembly on the back of the body.
2. Pull out the front panel assembly and the rear panel
assembly. Disconnect the speaker terminal on the
front side and connector CN112 on the connection
board on the rear side at the same time.
Removing the CD mechanism assembly
section (See Fig.2)
Prior to performing the following procedures, remove
the rear panel assembly.
1. Disconnect the card wire from connector CN614 and
the wire from CN624 on the CD mechanism
assembly respectively.
2. Remove the three screws B
mechanism assembly section.
Removing the
assembly (See Fig.3)
Prior to performing the following procedures, remove
the rear panel assembly and the CD mechanism
assembly section.
1. Disconnect the card wire from connector CN33,
CN34 on the cassette mechanism assembly.
2. Remove the four screws C
mechanism assembly with the wire cover.
attaching the CD
cassette mechanism
and the cassette
A
A
Connection board
CN112
A
Fig.1
CN624
B
B
Cassette mechanism assembly
Fig.2
CN33
C
Cassette mechanism
C
assembly
Fig.3
RS-WP1WT
A
A
Rear panel
assembly
A
B
CN614
CD mechanism
assembly section
CN34
C
Wire cover
1-5