Table of Contents
Advertisement
CH-X470RF
Disassembly method
Perform operations according to the items to be
disassembled.
<Replacement of the pickup>
1.
After removing the exterior (top and bottom).
2.
Proceed to the pickup replacement section.
3.
When applying grease, refer to the exploded view.
Use new grease.
<Mechanism section>
1.
Remove the exterior (required section only).
2.
The mechanism section is designed so that each unit
can be removed separately.
3.
When reassembling, refer to the assembling
precautions. (Use new grease when applying grease.)
<Exterior section>
Removing the bottom cover and front
panel assembly
1.
Remove the two screw A to unlock the mounting
direction knob located on the side of the main unit.
2.
Turn the mounting direction knob in the direction of
the arrow using a coin, etc. to remove it. (The knob
can be removed only when it is set to this position.)
3.
Remove the four top cover fixing screws B at the
triangle
marks on the side of the main unit. (Perform
the same operation on both sides.)
4.
Turn the unit upside down so the bottom surface is
facing upward.
5.
Lift the rear edge of the bottom cover slightly and lift
the side by grasping the DIN jack section on the side
panel, then turn it toward the front (raise upward) to
remove the bottom cover.
6.
Unhook the four catches located on both sides of the
front panel, and turn the front panel toward the top
cover (lower down) to remove the front panel.
1-4
Remove A and turn in
the direction of the arrow
(See Fig.1 to 4)
The front panel can be
separated by raising the cover.
Unhook catches
B
B
A
B
Fig. 1
B
Bottom cover
Knob
Fig. 2
Fig. 3
Front panel
Fig. 4
B
Bottom cover
Knob
Remove A and turn in
the direction of the arrow.
B
B
A
B
Bottom cover
Slightly lift the jack
section to remove.
Unhook catches
Advertisement
Table of Contents
