JVC RS-WP1WT Service Manual page 12

RS-WP1WT
<CD mechanism assembly section>
Prior to performing the following procedures, remove
the rear panel assembly and the CD mechanism
assembly section.
Removing the CD mechanism assembly
(See Fig.22 to 26)
CAUTION: Prior to disconnecting the flexible wire
extending from the pickup, solder it to the
short circuit land to prevent damage to the
pickup.
1. Release the three joint hooks d retaining the CD
mechanism cover.
2. Disconnect the wire from connector CN612 on the
CD servo board.
3. Remove the CD mechanism assembly from the three
dampers.
4. Solder the flexible wire connected to connector
CN611 on the CD servo board to the short circuit
land under the flexible wire.
After soldering, disconnect the pickup wire from
connector CN611.
CAUTION: When reassembling, connect the pickup
wire extending from the pickup to
connector CN611 on the CD servo
board. Then unsolder the wire soldered
to the short circuit land.
Short circuit land
1-12
CN611
Fig.26
CD mechanism cover
Joint hook d
Fig.22
Joint hook d
Fig.23
Damper
Damper
CN611
Fig.24
CD mechanism board
Fig.25
Joint hook d
CD mechanism cover
CD servo board
Damper
CN612
CD servo assembly
CD mechanism assembly
(Pickup)
Pickup wire
(Short circuit land)