JVC RS-WP1WT Service Manual page 6

RS-WP1WT
Removing the function switch board
Prior to performing the following procedures, remove
the rear panel assembly.
1. Disconnect the card wire from connector CN921 on
the function switch board.
2. Remove the two screws D and move the function
switch board in the direction of the arrow to
disengage the two joints a.
Removing the LCD spare board / LED
board (See Fig.5 and 6)
Prior to performing the following procedures, remove
the rear panel assembly.
1. Remove the LCD spare board while pulling each
joint hook b outward.
2. Pull out the LED board.
If necessary, unsolder FW925 soldering the wire on
the LED board.
1-6
(See Fig.4)
CN921
LCD spare board
Joint hook b
LED board
FW925
Joint a Joint a
D
Fig.4
LCD board
Joint hook b
Fig.5
LCD board
Fig.6
Function switch board