JVC RS-WP1WT Service Manual page 9

Removing the remocon board
Prior to performing the following procedure, remove
the rear panel assembly.
1. Remove the screw M attaching the remocon board
and disconnect the wire from connector CN913 on
the LCD board.
Removing the tuner board (See Fig.15)
Prior to performing the following procedures, remove
the rear panel assembly.
1. Disconnect the card wire from connector CN1 and
the antenna wire from TP1 on the tuner board
respectively.
2. Remove the four screws N
board.
(See Fig.14)
attaching the tuner
M
Remocon board
Fig.14
Tuner board
CN1
N
Antenna wire
TP1
Fig.15
RS-WP1WT
LCD board
CN913
N
1-9