Opening The Battery Retaining Clip - HP ProLiant BL20p Maintenance And Service Manual

IMPORTANT: Run the System Utility to configure the system after replacing the battery. Refer to the
HP ProLiant BL p-Class System Setup and Installation Guide for more information.
To remove the system board battery:
1. Power down the server blade and remove it from the server blade enclosure. Refer to
"Server Blade Preparation" in this chapter.
2. Remove the access panel. Refer to "Access Panel" in this chapter.
3. Locate the battery holder on the system board.
4. Remove the existing battery by pushing the tab aside and pulling the battery straight up.
Figure 2-25: Opening the battery retaining clip
To install the system board battery, push it into the socket until the tab locks in place.
HP ProLiant BL20p Generation 2 Server Blade Maintenance and Service Guide
HP CONFIDENTIAL Codename: Part Number: 316078-001 Last Saved On: 4/3/03 1:22 PM
CAUTION: Batteries, battery packs, and accumulators should not be disposed of
along with general household waste. In order to forward them for recycling or proper
disposal, please use the public collection system, or return them to the authorized
partners or their agents.
Removal and Replacement Procedures
2-25