Advertisement
Installation
Instructions
ROLLERS
The rollers have 3 purposes:
m Rollersadjust so the door closes easily when opened
about halfway. [Raisethe front about 5/8" (16 mm)
from the floor.]
m Rollersadjust so the refrigerator is firmly positioned
on the floor and does not wobble.
m Rollersallow you to move the refrigerator away from
the wall for cleaning.
Final leveling adjustments should be made after
the refrigerator has been installed.
To adjust the rollers on 25', 27' and 29' models:
mTurn the roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise to
lower it. Use a 3/8"
hex socket or wrench,
or an adjustable
wrench.
Roller adjusting screw
To adjust the rollers on 21' and 23' models:
0
Remove the base grille by opening the doors, removing
the screws at each end, and pulling it straight out.
0
Turn the front roller
adjusting screws
clockwise to raise
the refrigerator,
counterclockwise to
lower it. Use a 3/8"
hex socket or wrench,
or an adjustable
wrench.
Roller adjusting screws
@
These models also have rear adjustable rollers so you
can align the refrigerator with your kitchen cabinets.
Use a long-handled 5/!6" socket wrench to turn the
screws for the rear rollers-clockwise to raise the
refrigerator, counterclockwise to lower it.
Replace the base grille.
DOOR ALIGNMENT
After leveling, make sure that the refrigerator door is 1/!6"
higher than the freezer door.
To align the doors, adjust the refrigerator door.
Using a 7/16" socket wrench, turn the door adjusting
screw to the right to raise the door,to the left to lower
it. (Anylon plug, imbedded in the threads of the pin,
prevents the pin from turning unless a wrench is used.)
0
After one ortwo turns of the wrench, open and close
the refrigerator door and check the alignment at
the top of the doors.
Refrigeratordoor
_
needsto be raised.
To remove the basegrille,
open the doors,remove
the screwat eachendof
the basegrilleandthen
pullthe grillestraightout.
7/16" Socket W rench]
26
Advertisement
