Advertisement
About the automatic icemaker.
A newlg-installed
refrigerator
may take 12 to 24 hours to begin
making
ice.
Power
switch
Icemaker
Automatic
Icemaker
The icemaker will produce seven cubes
per cycle-approximately 100-!30 cubes
in a 24-hour period, depending on freezer
compartment temperature, room temperature,
number of door openings and other use
conditions.
Toaccess the icemaker: Pull the shelf above
Green,
the ice drawer straight out. Always be sure
Power Light
_rArm
to replace the shelf.
If the refrigerator isoperated before the water
....
connection is made to the icemaker,set the
power switch in the O position.
When the refrigerator has been connected
to the water supply, set the power switch
to the I position.
You will hear a buzzing sound each time
the icemakerfills with water.
Pull the upper freezer shelf straight
out to access the icemaker. Always
be sure to replace the shelf The
shelf can be used for storage.
-& WARNING:
Connectto potable
water supply only. Installation of the icemaker
must be done bg a qualified service technician.
The icemaker will fill with water when it cools
to - 10°C.A newly-installed refrigerator may take
12 to 2/4hoursto begin making ice cubes.
Special note about ClimateKeeper2 T" d ispenser
models:
Dispenser models have a tilt-out ice bin.
The bin can be tilted out as shown in
the illustrations, and it will hold itself up while
you take ice out or turn the icemaker power
switch on and off. Be sure to put the bin back
in place before closing the door.
_To restore your ice levelfrom an empty bucket
stage,the following stepsare recommended:
O
12 hours after the first batch of ice has fallen
into the bin, dispense 3 to 4 cubes.
O
After an additional 6 hours, dispense 3 to/4
cubes again.
These steps will restore your ice level
in the shortest amount of time.
On dispenser models with a tilt-out ice bin, to
access ice or reach the power switch:
Throw away the first few batches of ice to allow
the water line to clear.
Be sure nothing interferes with the sweep
of the feeler arm.
When the bin fills to the level of the feeler arm,
the icemaker will stop producing ice. It is normal
for several cubes to be joined together. If ice is
not usedfrequently, old ice cubes will become
cloudy, taste stale and shrink.
If ice cubes get stuck in the icemaker,the green
power light will blink. To correct this, set the
power switch to O and remove the cubes.
Setthe power switch to I to restart the icemaker.
After the icemaker has been turned on again,
there will be a delay of about/45 minutes before
the icemaker resumes operation.
NOTE:In homes with !ower-than-avemge water
pressure,gou mag hear the icemaker cgcle
multiple times when making one batch of ice.
o
Lift the bin, then pull it forward until the bin stops.
o
ower the bin to access ice or reach the power
switch.
NOTE: In order to take full advantage of the tilt-out ice bin,
onlg store items on the shelf below the ice bin that are no
taller than the lowest point on the bin.
ii
Ice Storage
Drawer
To access ice, pull the drawer forward.
To remove:
Setthe icemaker power switch to the O (off]
position. Pull the drawer straight out and
then lift past the stop position.
To replace:
When replacing the drawer, be sure to press
it firmly into place. If it does not go all the way
back, remove it and rotate the drive mechanism
1//4turn. Then push the drawer back again.
Drive
Mechanism
15
Advertisement
