ENFORCER PA-U0405-NULQ User Manual

ENFORCER 4-Channel CCTV "Brick" Power Supply

Troubleshooting:

Camera will not turn on
No output power from power supply
Also Available from SECO-LARM:
CCTV Plug-in
Power Supplies AC Adapters
PS-U1812-PULQ ST-UV12-S1.0Q
LIMITED WARRANTY:
This SECO- LARM product is warranted against defects in material and workmanship while
used in normal service for two (2) years from the date of sale to the original customer. SECO- LARM's obligation is limited to
the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty
is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or
alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO- LARM determines that such
equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole
obligation of SECO - LARM and the purchaser's exclusive remedy, shall be limited to the replacement or repair only, at
SECO-LARM's option. In no event shall SECO-LARM be liable for any special, collater al, incidental, or consequential
personal or property damage of any kind to the purchaser or anyone else.
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO- LARM reserves the right to
change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors. Trademarks
are the property of SECO-LARM U.S.A., Inc. or their respective owners.
Copyright © 2014 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
®
SECO-LARM U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800
4
• Make sure that all wires are connected securely and that
the polarity is correct
• Check to see that the main power cable is securely
connected to the power supply
• Check the total supply current for all connected device
does not exceed 5A
Plug-and-Play Voltage
Backup Batteries Converters
(SB-P1012-26Q shown)
SB-L10V1-20Q /
ST-LA130-TTQ
SB-P1012-26Q
Website: www.seco-larm.com
Email: sales@seco-larm.com
MiPA-U0405-NULQ_141013.docx
SECO-LARM U.S.A., Inc.
4-Channel CCTV "Brick" Power Supply
PICSN7
PA-U0405-NULQ
Manual