Download Print this page

ENFORCER ST Series Manual

Power supplies/chargers

Advertisement

Quick Links

Features:
 Automatic recharging of backup batteries
 Automatic switchover to backup battery if
main power is lost or cut
 Built-in battery short-circuit protection
 LEDs indicate power status
 High efficiency at full load
 Heat sink free design (except for
ST-2406-7AQ and ST-2406-10AQ)
ST-Series
Power Supplies/Chargers
Manual
ST-2406-3AQ shown
 Programmable DC voltage output
 Regulated and filtered output voltage
 Fused output for a regulated charge
 Includes foam tape and battery leads
for easy installation
 Low-battery cutoff (ST-2406-2AQ,
ST-2406-3AQ, and ST-2406-5AQ)

Advertisement

loading
Need help?

Need help?

Do you have a question about the ST Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for ENFORCER ST Series

  • Page 1 ST-Series Power Supplies/Chargers Manual ST-2406-3AQ shown Features:  Automatic recharging of backup batteries  Programmable DC voltage output  Automatic switchover to backup battery if  Regulated and filtered output voltage main power is lost or cut  Fused output for a regulated charge ...
  • Page 2 ENFORCER Power Supplies/Chargers Introduction: SECO-LARM’s ST-series of power supplies/chargers ensure that alarm systems and access control systems have enough power to do their job. Protected by fused outputs, input polarity protection diodes, and backup battery polarity reverse protection, these power supplies/chargers can be used to maximize the security and efficiency of nearly any alarm or access control installation.
  • Page 3 ENFORCER Power Supplies/Chargers Installation: 1. Mount the PC board in the desired location or enclosure. It should be easily accessible for future servicing. Table 1: 2. Set the DC power output: Voltage a. Set the desired DC output voltage (6, 12, or 24VDC*) of the power supply using the DIP switch as in Table 1 (for ST-1206-1.5AQ,...
  • Page 4 ENFORCER Power Supplies/Chargers Also Available from SECO-LARM ® 12VDC High-Amp Switching CCTV Relay Boards Low Battery Cutoff Timers Power Supplies PS-U1812-PULQ shown SR-2212-C5AQ shown ST-BD01Q SA-025EQ shown 12VDC Plug-In Plug-and-Play Open-Frame Power Converters AC Adapters Backup Batteries Transformers ST-UV12-S1.0Q shown...

This manual is also suitable for:

St-1206-1.5aqSt-2406-2aqSt-2406-3aqSt-2406-5aqSt-2406-7aqSt-2406-10aq