Installation
Instructions
[STEP 5 LEVEL REFRIGERATOR
All models have 4-point
leveling, The front is supported
by leveling legs, the rear is supported
by adjustable
wheels, Both are accessible
from the front of the
refrigerator,
. To level the back of the refrigerator,
turn the 7/16" hex
nut located above the front wheels, Turn clockwise
to
raise or counterclockwise
to lower the refrigerator,
. For front leveling, use a 1-1/4" open-end
wrench,
. Adjust height of refrigerator
to match installation
cutout opening
83-1/2 to 84-1/2", The refrigerator
should be level and plumb with cabinetry,
U
Hex Nut Adjusts -_!_
RearWheels
Leveling
CAUTION:
The rear leveling wheels and front leveling legs are
limited to a maximum
height adjustment
of 1", If the
installation
requires more than 84-1/2"
height, the
installer should elevate the refrigerator
on a sheet
of plywood
or runners, Cabinetry
trim could also be
added across the top of the opening
to shorten the
opening, If you attempt
to raise the refrigerator
more
than 1", you will damage the front leveling legs and the
rear leveling wheels,
PRUDENCE
Les roues de nivellement
arriere et les pattes de
nivellement
avant permettent
un reglage maximal
de 25 mm (1 po), Si I'ouverture
pour le refrigerateur
a une hauteur
superieure
_ 2,15 m (84-1/2 po),
I'installateur
dolt elever le refrigerateur
sur une feuille
de contre-plaque
ou des glissieres, II est egalement
possible d'ajouter
des baguettes
de finition des
placards
sur le haut de I'ouverture
afin de la reduire,
Lever le refrigerateur
de plus de 25 mm (1 po)
endommage
les pattes de nivellement
avant
et les roues de nivellement
arriere,
STEP 6 SECUREUNIT TO WALL
The "L" rod can be found in the upper left corner of
the unit in the access compartment,
Look through
the
access compartment
to make sure the rod lines up with
the anti-tip
bracket,
There are 2 washers
and a hair pin cotter with the rod,
Remove the washers and hair pin cotter from the end of
the rod,
Rotate and move the
,:: .......
"L" rod into the slot in
: .....
the anti-tip
bracket tab,
"
----.
Once it is in the slot,
rotate the "L" rod so the
hook portion is pointing
',,,
,,,
down, The holes at the
',,
front end of the rod
"L" Rod Pointing Down
should be in a vertical
Engaged i nBracket
position,
Pull out on the end of the rod to make sure it is secure
in the bracket,
Locate the hole on the rod that is closest to the unit, A
hair pin cotter will be put through
this hole to secure the
rod, If this hole appears to be too far away for a snug fit
against the unit, add the washers one at a time until the
pin will fit tightly into the hole,
Align the straight
section of the pin with the hole from
the underside
of the rod, Push the pin up until it snaps
into position, Pliers may be used, NOTE: The hair pin
cotter must be vertical
when this step is completed
to
ensure the "L" rod is engaged
in the bracket,
Check the rod for tightness
by pulling forward,
If the rod
moves, remove the hair pin cotter and place another
washer on the rod, Reinsert the pin,
"L" Rod
/
Hair Pin Cotter
is Vertical
13