Table of Contents
Advertisement
Installation
Instructions
[STEP 4 ]INSTALL ANTI-TIP BRACKET
(cont.)
Install Wall Toggles:
The wall toggles and bolts can be ordered
as Service Kit
#WR49X10193,
Wall toggles are installed
in the drywall
and metal studs for stability,
Install the wall toggles as
follows:
. Drill 1/2" holes at the wall markings
made in the holes at
the ends of the wall bracket,
. Hold the metal channel flat against the plastic straps
and slide the channel through
the hole,
. Insert the bolts into the toggle by hand until snug,
Tighten with a wrench,
Drywall o r
Steel S tud
\\
\\
B01t
Metal Channel
. Gently pull back at the ends of the plastic straps to
make the channel
rest flush behind the wall,
. Hold the ends of the straps in one hand and slide the
plastic cap along the straps until the flange of the cap is
flush with the wall,
. Place your thumb between
the plastic straps and bend
up and down to snap the straps off at the wall,
Anti-Tip Wall Bracket
Wall Toggle
Power Cord
Locate the power cord inside the left cavity, If it has not
been adjusted
so the plug is easily accessible,
do so now,
"L"Bolt
/
Power Cord Location
Install
Screws and Bolts:
. Have someone
hold the wall bracket centered
in place
with each of the holes aligned with the correct opening
in the bracket and level with the horizontal
line,
. Insert the lag screws through
the bracket
and into the
stud, Tighten with a wrench,
Wood Stud
Move Unit into Final Position
. Open the access panel,
. Move refrigerator
toward
its final installed
location, Align
the tabs on the wall bracket with the openings
in the back
of the unit,
. The unit has an "L" bolt in the upper left corner inside of
the access compartment,
This bolt will interlock with the
wall bracket and secure the unit using the washers
and
hair pin cotter in the hardware
kit once the unit has been
leveled and is in the final position,
Anti-Tip Wall Bracket
12
Advertisement
Table of Contents
