Step 9, Secure Refrigerator To Cabinetry; Step 10, Adjust Door Swing; Step 11, Install Grille Panel - GE ZISS480NXBSS Installation Instructions Manual

Installation Instructions
ESTEP9] SECURE REFRIGERATOR
TO CABINETRY
Whenever possible, perform this step for anti-tip
securitg, or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access the case trim.
• Drill a hole in the trim and drive a screw through
the trim into the adjacent cabinet.
• Follow the same procedure on the opposite side.
ThroughCaseTrimInto
AdjacentCabieets
ESTEP10] ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fullg to 130°, gou mac change the door swing to a 90°
opening. Skip this step if door opening is satisfactorg
for gour installation situation,
130 °
letedor
Door
Hiege
• Open the door to view the bottom hinge.
Note the door stop pin locations. The pin is factorg
installed in the 130° position.
• Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 90° position.
ESTEP11] INSTALL GRILLE PANEL
(for Custom Panel Models onlg)
To insert the framed or overlag panel into the grille:
• Raise the grille panel to the stop position.
\
/
Loosen
Side Side
Trim Trim
Screw Screw
AdjustNut Below
Spring to Accommodate
Panel W eight
• Loosen the screws on the side trim behind the frame.
Remove the bottom trim.
CAUTION:
The metal panel mac be
slipperg. Grip the metal panel firmlg so the panel
does not slip out of the frame and cause personal
injurg or damage to the frame.
PRUDENCE :
Lepanneauen m&talpeut
b_tre glissant. Tenir fermement le panneau en m&tal,
de mani_re 6 ce que le panneau ne glisse pasen
dehors du cadre en provoquant des blessures
corporelles ou des dommages au cadre.
• Slide the panel over the metal backer panel and into
the trim.
• If necessarg, tap with a wood block until the panel
slips under the top trim piece.
• Reassemble the bottom trim. Tighten the screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessarg.
14