Control Panel Features - Kenmore 796.91582410 Use & Care Manual

A WARN ING: To ,eduoe fh°, ,k of el, ,ic ,ho0k. o,i,io,V to ,eod f hl, o ,,,o
manual, including fee Important Safety Instructions, before operating fhls dryer.
CONTROL PANEL FEATURES
I
No_'mal
Heavy Du_
Bulk_l_mf_,
Khaki FJeans
Sanitize
Cas_|
Workout Veer
De +COtes
Srn_|l Load
Expre_ Dry
Touch Up
Air D_y
Extra Dry
Normal
D_p Dry
50
40 LOU_
20 Off
I
O
O
0
0
POWER (ON/OFF) BUTTON
Pressto turn the dryer ON or
OFF.
Pressing the
POWER button during a cycle will cancel that cycle
and any settings will be lost.
CYCLE SELECTOR KNOB
The cycle selector knob is used to select the desired
dry cycle by rotating the knob in either direction until
the desired cycle LED is illuminated. Once the desired
cycle has been selected, the standard presets for that
cycle will show in the display. These settings can be
adjusted using the cycle modifier or option buttons
any time before starting the cycle.
@
@
START/PAUSE BUTTON
Press this button to start the selected cycle. The
dryer will display the estimated time (AUTO DRY) or
set time (TIMED DRY) remaining and start tumbling.
To pause the cycle at any time, open the dryer door
or press START/PAUSE. To resume the cycle where it
was stopped, press START/PAUSE again.
NOTE: If the dryer has been stopped for more than
four minutes, the dryer will turn off: automatically.
OPTION BUTTONS
These buttons allow you to select cycle options.
Some of the option buttons have secondary
functions. The controls can be locked or unlocked by
pressk_g and holding the WRINKLE GUARD button
for five seconds.
CYCLE MODIFIER BUTTONS
Use these buttons to adjust the settings
for
the
selected cycle. The settings light up above the
buttons to show the current selection. The default
temperature setting cannot be changed in AUTO
DRY cycles. AUTO DRY cycles are modified using
the DRY LEVEL button.
TIME AND STATUS DISPLAY
The display shows the estimated time remaining for
auto cycles and actual time for timed cycles. The
status of the cycle is also displayed. The CHECK
VENT indicator will illuminate if there is a serious
restriction in the exhaust system.
STEAM FUNCTIONS
The STEAM REFRESHcycle uses a swirling jet of
steam to refresh clothes. The STATIC SHIELD and
IRON READY options are also available for most
cycles.
STEAM FEEDER
This drawer contains the reservoir for the water used
by the dryer to create the steam used for the steam
cycle and options. Fill the steam feeder with tap
water to take advantage of the power of steam for
fresher, static-free fabrics.
NOTE: To protect your fabrics, not all settings are allowed in aH cycles.
]8