Craftsman 5411.3 Operator's Manual page 8

Keepcuttingtoolssharpandclean.Properly m aintained cutting toolswith
sharp cutting edges arelesslikely to bindandareeasier to control.
Usethe
power tool, accessories, tool bits, etc. in accordance with
these instructions, taking into account the working conditions and the
work to be performed. Use of the power tool for operations different from
those intended could result in a hazardous situation.
BATTERY TOOL USE AND CARE
• Recharge only with the charger specified by the manufacturer. A
charger that is suitable for one type of battery pack may create a risk of fire
when used with another battery pack.
• Use power tools only with specificaNy designated battery packs. Use of
any other battery packs may create a risk of injury and fire.
= When battery pack is not in use, keep it away from other metal objects,
like paper clips, coins, keys, nails, screws or other small metal objects
that can make a connection from one terminal to another. Shorting the
battery terminals together may cause burns or a fire.
= Under abusive conditions, liquid may be ejected from the battery;
avoid contact, if contact accidentally occurs, flush with water, if liquid
contacts eyes, additionally seek medical help. Liquid ejected from the
battery may cause irritation or burns.
SERVICE
Have your power tool serviced by a qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
Follow instructions in the Maintenance section of this manual. Use of
unauthorized parts or failure to follow Maintenance instructions may create
a risk of shock or injury.
SPECiFiC SAFETY RULES FOR CIRCULAR SAW
Safety instructions for all saws
,_ DANGER: Keep hands away from cutting area and the blade. Keep your
second hand on auxiliary handle, or motor housing, if both hands are holding the
saw, they cannot be cut by the blade.
• Do not reach underneath the workpiece. The guard cannot protect you
from the blade below the workpiece.
Adjust the cutting depth to the thickness of the workpiece. Less than a
full tooth of the blade teeth should be visible below the workpiece.