Jointer; Cutting Depth; Fence Angle; Switch Action - Makita 2030N Instruction Manual

JOINTER
1. Cutting depth
Set the depth of cut with the depth
adjustment knob while watching the
graduation on the
scale
plate.
Fig.
6
2. Fence angle (0
-
45')
Set the depth of cut to "0" graduation.
Loosen the thumb screws holding the
fence in place. Pull out the fence by at
least
25
mm
(1")
and tighten the thumb
screws.
Loosen the hex bolts ( A ) and (B) and
tilt
the fence.
Fig. 7
At the desired angle, tighten the hex bolts, making sure that the bolt (A) is tightened
first and the bolt (BI second. (Refer to
Fig.
7). About 0.5 mm (1/64") clearance be-
tween, the lower edge
of
the fence and the table top
is
necessary for the correct setting.
3 .
Switch action
To start the tool, the key and the ON-
button must be pressed in.
Press the OFF-button to stop.
The
tool is
switched off automatically
when the electric current i s cut
off.
CAUTION :
When not using the tool, remove the
key. (This prevents unauthorized opera-
tion.)
Fig. 8
9