VARIOUS ADJUSTMENTS
1. Adjusting infeed/outfeed rollers (Auto-planer)
NOTE :
The planer infeed and outfeed rollers are factory adjusted. If you notice the adjust-
ment is off, kindly do
as
follows.
Use the wrench to loosen the installation nuts slightly. Turn the adjusting screw to
obtain a level of from 0.1 to
0.3
mm above the table surface.
It i s relatively simple to make the setting so that a postcard can slip in and out be-
tween the roller and the leveler. After adjusting rollers, be sure to tighten installation
nuts securely.
A roller that protrudes too much will cause gouging or shiping in the workpiece and
rough surfaces.
2. Extension roller adjustment
Gently loosen the hex bolts, set a rule
or yardstick on the table surface and ad-
just
so
that roller arm
is
slightly higher
than the table. Tighten the hex bolts
securely so that the roller arm surface is
a t
90"
to the column.
Roller shaft
Roller
3
mm
Fig. 2 1
16