Download  Print this page

Advertisement

INSTRUCTION MANUAL
Thicknesser
2012NB
004461
DOUBLE INSULATION
IMPORTANT: Read Before Using.
1

Advertisement

   Related Manuals for Makita 2012NB

   Summary of Contents for Makita 2012NB

  • Page 1

    INSTRUCTION MANUAL Thicknesser 2012NB 004461 DOUBLE INSULATION IMPORTANT: Read Before Using.

  • Page 2: Specifications

    EC Declaration of Conformity facility. ENE001-1 Makita Corporation responsible Intended use manufacturer declare that the following Makita The tool is intended for planing wood. machine(s): ENF002-1 Designation of Machine: Power supply Thicknesser The tool should be connected only to a power supply of Model No./ Type: 2012NB...

  • Page 3

    The technical documentation is kept by our authorized contain long hair. representative in Europe who is: Use safety glasses and hearing protection. Makita International Europe Ltd, Also use face or dust mask if the cutting operation Michigan, Drive, Tongwell, is dusty.

  • Page 4: Functional Description

    breakage of parts, mounting and any other WARNING: conditions that may affect its operation. A guard or DO NOT let comfort or familiarity with product other part that is damaged should be properly (gained from repeated use) replace strict adherence repaired or replaced by an authorized service to safety rules for the subject product.

  • Page 5: Adjusting Depth Of Cut

    Switch action 1. Depth gauge 1. Pilot lamp 2. Switch 004466 Insert the workpiece flat on the table top. Lower the main 004463 frame by turning the crank handle counterclockwise. The CAUTION: depth gauge will rise and the amount of gauge rise Before plugging in the tool, always be sure that the •...

  • Page 6

    thrown away. Stopper Removing blades 1. Stopper Loosen the thumb screw which secures the chip cover 2. Stopper button and remove the chip cover. Remove the screws which 3. Stopper knob secure the right side cover. Then remove the right side 4.

  • Page 7

    004469 Installing blades CAUTION: 003717 Use only Makita socket wrench provided to tighten • Install the other blade as described above. Rotate the the blade installation bolts. The use of any other drum slowly while pressing the lock plate to make sure socket wrench may cause overtightening or there is nothing abnormal.

  • Page 8

    Slip the heel of the set plate into the groove in the drum. Hood set Install the blade installation bolts. 1. Hood set 1. Set plate 2. Groove 3. Blade 4. Drum 004473 004471 When you wish to maintain clean operations through After tightening all the blade installation bolts tightly and easy dust collection, connect the vacuum cleaner to the evenly from the center to the outside, tighten them...

  • Page 9: Replacing Carbon Brushes

    Switch on the tool and wait until the blades attain full Adjusting height of sub-table speed. The workpiece should not be in contact with the feed roller when you turn the tool on. 1. Ruler Then insert the workpiece flush with the table top. 2.

  • Page 10

    Keeping blades sharp If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Dull blades can cause rough finish, an overload of the Magnetic holder motor and dangerous kickback of the workpiece.

  • Page 12

    Makita Corporation Anjo, Aichi, Japan www.makita.com 884278C227...

Comments to this Manuals

Symbols: 0
Latest comments: