Thermal Camera Connection - Raymarine gs series Installation Instructions Manual

Connecting the data cable
Follow the steps below to connect your HD-SDI data
cable to the multifunction display.
1
3
1. Ensure the BNC connector is correctly orientated.
2. Fully insert the BNC connector into the relevant
HD-SDI connection on the back of your
multifunction display and turn the locking collar
clockwise until locked into position.
3. Push the protective boot over the BNC connector
and HD-SDI connection on the back of the
display.
4. Use 2 cable ties (supplied) to secure the
protective boot over the connection.
Protecting disconnected cables
If a BNC cable is to be left disconnected then the
protective cap should be secured to the end of the
boot.
1 2
1. Disconnected the BNC cable from the
multifunction display.
2. Push the boot over the cap as shown below.
3. It is recommended that a cable tie be used to
secure the boot to the cap.
HD-SDI maximum cable length
The maximum recommended cable length is shown
below.
HD-SDI input cable
50
2
4
D13048-3
3
D13050-1
50 m (164 ft.)

4.25 Thermal camera connection

Thermal cameras can be connected directly to the
display's network connection or can be connected to
the SeaTalk hs network, via a Raymarine
switch.
2 connections are required:
• Network connection — required to control the
thermal camera via a compatible Raymarine
MFD or optional Joystick Control Unit (JCU).
• Video connection — transmits the composite
video signal to a compatible Raymarine
Note: The Thermal camera can only be connected
to MFDs with a Video input connection.
T200 Series connection
1. MFD
2. Thermal camera
3. Power over Ethernet (PoE) Injector
4. RayNet to RJ45 SeaTalk
5. Network connection to MFD (RayNet)
6. Video connection to MFD (composite video)
7. Video cable
T300 / T400 Series connection.
2 3
SeaT alk
5
8
1. MFD
2. Video connection to MFD (composite video)
3. Network connection to MFD (RayNet cable)
® network
® MFD.
1
4 5
hs adaptor cable
1
4
hs
/ RayNet
6
hs
SeaT alk / RayNet
7
9
10
hs
SeaT alk / RayNet
gS Series installation instructions
®
6
7
D12839-2
D12260-2