Warnings; Site Preparation - Motorola AP-7131 Installation Manual

2
AP-7131 Access Point: Installation Guide

1.2 Warnings

Read all installation instructions and site survey reports, and verify correct equipment installation before
•
connecting the AP-7131 to its power source.
Remove jewelry and watches before installing this equipment.
•
Verify that the unit is grounded before connecting it to the power source.
•
Verify that any device connected to this unit is properly wired and grounded.
•
Connect all power cords to a properly wired and grounded electrical circuit.
•
Verify that the electrical circuits have appropriate overload protection.
•
Attach only approved power cords to the device.
•
Verify that the power connector and socket are accessible at all times during the operation of the
•
equipment.
Do not work with power circuits in dimly lit spaces.
•
Do not install this equipment or work with its power circuits during thunderstorms or other weather
•
conditions that could cause a power surge.
Verify there is adequate ventilation around the device, and that ambient temperatures meet equipment
•
operation specifications.

1.3 Site Preparation

Consult your site survey and network analysis reports to determine specific equipment placement, power
•
drops, and so on.
Assign installation responsibility to the appropriate personnel.
•
Identify and document where all installed components are located.
•
Provide a sufficient number of power drops for your equipment.
•
Ensure adequate, dust-free ventilation to all installed equipment.
•
Identify and prepare Ethernet and console port connections.
•
Verify that cable lengths are within the maximum allowable distances for optimal signal transmission.
•